Bilt Hamber New Touch-Less 5 Litre & Touch-On x 10 Sachets.
Bilt Hamber Touch-System is our new eco-friendly pressure- washer, pre-clean, snow foam which can be applied by pump spray or spray head too. Applied from 0.5% to 2% PIR this bio-degradable sugar-based product provides truly exceptional levels of cleaning of automotive paintwork.
Unlike other petrochemical-based cleaners, Touch-Less is free-and-easy rinsing, easing the effort of subsequent bucket washes and massively helping post-treatments bond too. Touch-Less also contains corrosion inhibitors. Packed in 5 litre pH ~10.5, contains no phosphates, solvents, NTA, or caustic soda.
Bilt Hamber Touch-Less is designed is to allow for superior and simple application of our new paint protection and shampoo product Touch-On, a pressure washer, pump-spray, or bucket applied durable hydrophobic ceramic paint protection treatment that additionally has low-foaming, powerful detergency for most second stage bucket washes so that you can further clean the paint while simultaneously applying protection following Touch-Less cleaning.
Once applied Touch-On has dirt releasing properties too that works in conjunction with Touch-Less in subsequent wash routines to produce superior contactless results. Packed in one dose sized 30ml sachets apply no more than 1 time per month. Touch-On is water-based, is not flammable nor contains alcohol or petrochemical solvents.
We do not recommend applying more than once a month. Car must not be allowed to air dry as water spotting may occur.
Contents:
1 x Touch Less (concentrated version) 5 Litre Jerrycan
10 x Touch on 30ml Sachets.
Bilt Hamber Touch System
Touch-Less:
TOUCH-LESS may be applied with trigger spray, pump spray, pressure washer, or snow foam lance. The minimum recommended dilution rate should be 0.5% PIR (Panel Impact Ratio) and up to 2% for very dirty vehicles. Where application is through trigger spray or pump spray, the dilution calculation is easy to achieve, however, for application with pressure equipment it is essential to determine the amount of water being delivered to the equipment reservoir.
Step 1
Fill the detergent bottle or reservoir (on machine or lance) up to capacity with plain water. Turn detergent feed to full. Take a large bucket or container and discharge the lance into this, watching the detergent bottle until empty. Once empty, stop.
Step 2
The following calculations will achieve 2% dilution; Measure the total amount collected and multiply this number by 0.02 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of TOUCH-LESS to use.
Step 3
Add the calculated amount from STEP TWO to the pressure-washer reservoir and top up to full with cold water and shake in for a few moments.
Step 4
Apply touchless to entire vehicle or panel by panel. Allow to soak for 1-5 minutes (but never allow to dry). Power-wash off.
It is not necessary to use all diluted touch-less in one wash. One litre of diluted product should last 4-5 washes. Apply to cool panels in shaded conditions. Do not allow this product to dry in use. Keep the bottle neck and lid clean.
Touch-On:
There are three methods that can be used to apply TOUCH-ON:
Empty 30ml sachet into empty power washer or lance reservoir, top up with clean water and apply at low pressure, then pressure rinse away and dry vehicle with a microfibre cloth.
Or...
Empty 30ml sachet into a 15 litre bucket of warm water and apply using noodle wash mitt. Rinse and dry with a microfibre cloth.
Can also be applied by trigger spray.
We do not recommend applying more than once a month. Car must not be allowed to air dry as water spotting may occur.
